Description :

The Backup Boot Flash Kit (Dual SO8N) is used as a Serial Flash Emulator for easy code development to reduce your time to market. Our Backup Boot Flash tool (included) can be connected to the application by 3 different methods:

  • On the Two Main Serial flash packages soldered on board by using our Dedicated BBF Test Clip (included).

  • On our Two SMT 1.27mm Pin Headers (included) soldered in place of the Two Main Serial flash footprints for a better stability by using the appropriate 2.54mm to 1.27mm cable adaptor-dual header (included)

  • On your application 2.54mm (2X5) BBF connector (if application designed with) by using the appropriate BBF cable (included).

Your application will work automatically on the Two Backup SPI Flash inserted in our tool is SO8N sockets that can be changed easily or even updated easily for new trials with our SF100 programmer (included). Our Kit is completely transparent for the application and will offer to developer high flexibility for code trials or update. The Kit is frequently used to boot failing computers and use the Flash Utility tools to update the corrupted Bios memories.

Please note the BBF modules does not support 1.8V low voltage IC.

Features :
  • Dual Serial Flash emulator transparent for the application
  • Compatible with most of the applications (no hardware modification needed)
  • Disable automatically the Two main serial flash soldered on board (no need to remove them)
  • Image download speed at 1Mbits/s to SPI flash and read at 2Mbits/s
  • USB Interface
  • Signal conflict protections

Contents :

  • 1 x SF100 Programmer (SF100) to update both Backup Serial Flash
  • 1 x Backup Boot Flash Module-Dual SO8N sockets (BBF-D8N)
  • 1 x BBF Test Clip-Dual SO8 Flash (BBF-2TC-8) for two Serial Flash: SO8N and SO8W compatible
  • 1 x BBF cable with 2.54mm pitch 2x5 female header
  • 2 x 1.27mm pitch 2x4 SMT male header
  • 1 x SO8 Connection Adaptor for BBF2 x cables with test grabber
  • 2 x cables with test grabber
  • 1 x SF100 ISP Cable (ISP1-CB)
  • 1 x USB cable
  • 1 x 1.27mm 2x4 cable with female header

Hardware Requirement :

  • The two Serial Flash Hold Pins must been pulled high through resistors (schematics available under request)
  • The two application Serial Flash memories must use the same SPI bus and been driven by two different Chip select.
  • Email to support@dediprog.com for schematic request.