The Backup Boot Flash Kit (SO8W) is used as a Serial Flash Emulator for easy code development to reduce your time to market. Our Backup Boot Flash Module (included) can be connected to the application by 3 different methods:

• On the Main Serial flash package soldered on board by using our BBF Test Clip(SO8) (included).

• On our SMT 1.27mm Pin Header (included) soldered in place of the Main Serial flash footprint for a better stability by using the appropriate BBF cable (included)

• On your application 2.54mm (2X5) BBF connector (if application designed with) by using the appropriate BBF cable (included).

Your application will work automatically on the Backup SPI Flash inserted in our tool is SO8W socket that can be changed easily or even updated easily for new trials with our SF100 programmer (included). Our Kit is completely transparent for the application and will offer to developer high flexibility for code trials or update. The Kit is frequently used to boot failing computers and use the Flash Utility tools to update the corrupted Bios memory.

Please note the BBF modules does not support 1.8V low voltage IC.

Features :

• Serial Flash emulator transparent for the application
• Compatible with most of the applications (no hardware modification needed)
• Disable automatically the main serial flash soldered on board (no need to remove it)
• Image download speed at 1Mbits/s to SPI flash and read at 2Mbits/s
• USB Interface
• Signal conflict protections

Contents :

• 1 x SF100 Programmer(SF100)
• 1 x Backup Boot Flash module with SO8W socket(BBF-8W)
• 1 x BBF testclip(BBF-TC-8)
• 1 x BBF cable with 2.54mm pitch 2x5 female header
• 2 x 1.27mm pitch 2x4 SMT male header
• 1 x SO8 Connection Adaptor for BBF
• 1 x 1.27mm 2x4 cable with female header
• 1 x USB cable
• 1 x SF100 ISP Cable (ISP1-CB)

Hardware Requirement :

• Pull up resistor between Hold Pin and Vcc if serial flash on application is not removed (schematics available under request)
• Email to support@dediprog.com for schematic request.