Designed to support ALL SPI Flash memories. Life-long software support without additional charges!! Race100 is a professional Gang Programmer dedicated and optimized for the Serial Flash memories. With the highest market performances and highest sockets parallelism, it offers the lowest possible programming cost for serial flash memories you could find in the market. The Programming time is in average 8 times faster than the Universal Gang Programmers, the sockets parallelism often 5 times bigger, increasing finally your Throughput capability by 40 with the same investment.
General :
- User Interface:Socket: Operation Status on LED (Pass, Running, Error), Keypad control, project management and production information on Gang LCD Display or PC monitor.
- Power: AC Voltage 100-240 VAC (50-60 Hz)
- Dimensions: Race100-S20 Width 50cm x height 7.2cm x depth 30.5cm. Race100-S8 & Race100-S4 Width 37cm x height 7.2cm x depth 24.5cm
- Memories Supported: all the Serial Flash (packages and families)
Software :
- Required: Race100SW
- File Type: binary, hex, Motorola
- Features: data editor, revision history, device and algorithm information, project setting, review/reset socket counter history, project history display and save to a file, standalone mode project configuration :load the image file with Checksum and define the operations on memory (all combination between: Blank Check, Erase, Program, Verify, Vpp support, protection)
Standalone mode :
- Device Operation: operate the pre-configured operation setting from the SD card in manual start or auto start after chips insertion
- Features: select project , display projects list, checksum, programming configuration setting, "socket counter" history (cycling, Pass, fail), "project counter" history, reset counters history
Features :
- Stand Alone mode controlled by Keyboard and wide LCD display.
- Easy to use: Define on computer and Load projects (Image and operations) to SD card. Operators only have to insert the SD card in the Race100 and select the project to be used. Race100 will run the project in Stand Alone mode (no need of computer).
Three advanced Working modes:
- Manual Start Mode: Sockets of the same cartridge work as a group. Operator has to press the “Start Button” of the Cartridge to start the operations on all the sockets. This mode reduces the risk of operator manual mistake on the working sockets.
- Auto Socket Start Mode: Each socket works independently, detects automatically the memory when inserted and start the operations instantly according to the project definition. This mode ensures the best throughput.
- Auto Cartridge Start Mode: Auto start when the 4 sockets of a cartridge are all filled with Serial flash memories.
- Production information in Real time: on Gang LCD display or PC monitor Best programming
- Quality and Reliability: ESD and over current protection, wrong insertion detection, self diagnostic etc. ensure the best signals quality and reliability.
