The “Backup Boot Flash Kit (Dual SO8W)” is used as a Serial Flash Emulator for easy code development to reduce your time to market. Our Backup Boot Flash tool (included) can be connected to the application by 3 different methods:

-         On the Two Main Serial flash packages soldered on board by using our Dedicated BBF Test Clip (included).

-         On our Two SMT 1.27mm Pin Headers (included) soldered in place of the Two Main Serial flash footprints for a better stability by using the appropriate 2.54mm to 1.27mmcable adaptor-dual header (included)

-         On your application 2.54mm (2X5) BBF connector (if application designed with) by using the appropriate BBF cable (included).

Your application will work automatically on the Two Backup SPI Flash inserted in our tool’sSO8W sockets that can be changed easily or even updated easily for new trials with our SF100 programmer (included). Our Kit is completely transparent for the application and will offer to developer high flexibility for code trials or update. The Kit is frequently used to boot failing computers and use the Flash Utility tools to update the corrupted Bios memories.

 

• Dual Serial Flash emulator transparent for the application
• Compatible with most of the applications (no hardware modification needed)
• Disable automatically the Two main serial flash soldered on board (no need to remove them)
• Image download speed at 1Mbits/s to SPI flash and read at 2Mbits/s
• USB Interface
• Signal conflict protections

• 1 x SF100 Programmer (SF100) to update both Backup Serial Flash
• 1 x Backup Boot Flash Module-Dual SO8W sockets (BBF-D8W)
• 1 x BBF Test Clip-Dual SO8 Flash (BBF-2TC-8) for two Serial Flash: SO8N and SO8W compatible
• 1 x BBF cable with 2.54mm pitch 2x5 female header
• 2 x 1.27mm pitch 2x4 SMT male header
• 1 x SO8 Connection Adaptor for BBF2 x cables with test grabber 
• 1 x SF100 ISP Cable (ISP1-CB)
• 1 x USB cable   
• 1 x 1.27mm 2x4 cable with female header 

• 1 x Backup Boot Flash with two SO8W sockets (BBF-D8W)
• 1 x BBF cable with 2.54mm pitch 2x5 female header
• 1 x SO8 Connection Adaptor for BBF
• 1 x 1.27mm 2x4 cable with female header
• 2 x 1.27mm 2x4 SMT male header
• 2 x cables with test grabber

• Pull up resistor between Hold pin and Vcc of the application serial flash if the application serial flash is not removed(schematic available upon request)
• The 2 application serial flash must use the same SPI bus been driven by 2 different chip select

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: