ISP Cable for SF600 - ISP-600-CB1-G
Click to enlarge |
|
The SF600 ISP cable is used to connect the ISP SF600 programmer to the 2X6 2.54mm ISP Pin Header on board offering the possibility to update directly the SPI Flash content. In case of frequent connections, the ISP cable must be time to time changed to ensure a good contact with the application board signals (production or repairing channel). The ISP updating method must only be used if supported by your application or controller.
Hardware :
Table 1: ISP Cable Connector Pin Out (2x6)
1
|
Vpp
|
CS2
|
2
|
3
|
CS1
|
Vcc
|
4
|
5
|
MISO/DQ1
|
Hold/DQ3
|
6
|
7
|
Wp/DQ2
|
CLK
|
8
|
9
|
GND
|
MOSI/DQ0
|
10
|
11
|
NC
|
Reset
|
12
|
Write Review
Your Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
There are no additional images for this product.