HardWare Connect
Insert the WiFi Module to the SDIO interface on the 210 board .
1. Android System
Press Menu(K2) and choose "Setting" to enter the Setting interface,
and choose "wireless & Network" -> "Wi-Fi", then you can use it.
2. Linux System
Go to the "FriendlyARM" tab and click on "WLAN Setting"
After the WLAN Setting utility is started it will automatically search for wireless AP and list their SSIDs and signal strength. If your utility doesn’t show sources please click on “Scan”
Connect with DHCP
After an AP is found click on its SSID to connect. The following dialog will pop up and you need to input its password:
After typing the password (leaving it as blank if no password is set) click on "Connect"
If the connection is successful, its status will show “connected”
If the WiFi connection is a success, you can minimize its GUI to a small icon by clicking on the “Close” button. To restore its GUI you can click on the small icon
Coonect with Static IP
In the main menu, click on “Configure IP” to start the IP configuration interface:
Click on the pull down menu you will see two options: “IP via DHCP” and “Configure IP manually”
After configuration is done, click on “Save” to keep your settings
3. WinCE System
Later will update...
|
